Magnetic Card Holder Sizes

One-touch magnetic card holders close with magnets, so there are no screws to fight with. They come in sizes by card thickness. The number in the size (35pt, 55pt, 100pt and so on) is the thickest card the holder is made to hold, in points. One point is one-thousandth of an inch.

Short answer: a standard base card is about 35pt, so use a 35pt magnetic holder. For relic and patch cards, measure the card and pick the size at or just above its thickness. If it falls between two sizes, go up.

Magnetic holder size chart

Holder size Typical cards
20pt Thin base cards, many vintage cards
35pt Standard base cards and most inserts
55pt Thick-stock inserts, some chrome and premium cards
75pt Thin relic and memorabilia cards
100pt Jersey relics and autograph relic cards
130pt Patch cards and thick relics
180pt Thick patch cards and multi-relic cards

How to measure your card

Use a digital caliper set to inches and multiply the reading by 1,000 to get points (0.035 inches is 35pt). Many relic and patch cards list their thickness on the back or on the pack. If you can't measure, compare the card to a standard base card from the same set. If it looks about twice as thick, start at 55pt or 75pt.

Should I sleeve the card first?

Yes. A penny sleeve protects the card surface and edges when it goes into the holder.

Magnetic holder or toploader?

Magnetic holders are a good fit for display and for cards you handle often. Toploaders are the lower-cost choice for storage and shipping. Not sure which size toploader you need? See what size toploader do I need.

Common questions

What size magnetic holder fits a regular card?
35pt.

What size fits a patch or jersey card?
Usually 100pt or 130pt. Measure first, since thickness varies.

Can I use a holder that is too small?
No. A tight holder can bend corners or stop the magnets from closing.

For sleeves, bags and cases too, see our full card holder size guide, or shop all magnetic card holders.